Description

Parameter: Material: Stainless Steel Main Color: Silver Model: JB-S2172-A Finish: Brushed Finish Recommended Maximum Load: 11lb The Diameter Of Center Post: 5/8" (15.9mm). The Diameter Of Suction Cup Base: 2.56" (65mm) Package Weight: 0.48 lbs (0.22KG) Installation Method: Suction Packaged Included: Waterproof Vacuum Suction Cup Hook Holder *2 Installation Instructions *1 Installation Steps: 1. Check to make sure the surface you applied the suction to is clean and smooth. 2. Hold the PVC base, rotate the stainless steel knob cap in an Anti-clockwise manner until it cannot be rotated, make sure the suction cup is in the pre-installed state. 3. Remove the plastic protective film. Make sure the PVC base is dry and clean. Place the suction cup perpendicularly and press firmly to exhaust the air. 4. hand hold the center of the suction cup, the other hand tighten knob cap in a clockwise manner until fully tight to ensure successful installation. How To Remove: Twist the knob cap in an Anti-clockwise manner until can not rotate. Pull up on the release tab to release the suction and remove. Wash PVC base bottom with water, reuse it after drying. Matters Needing Attention: 1. Overload-maximum weight 5KG (11lbs). 2. Suction cup work by the vacuum but the sticky PVC base which can help you place the suction cups easily. 3. It would not hold unless the surface is sealed to a point of stopping all air leakage. Please check again whether the wall is suitable for installation. 4. Be sure to the instructions on mounting. It does make a difference. Search “Suction Cup Series Installation Step” to watch more installation on . And there is an instruction sheet included plus detailed instructions come with the suction. Stainless Steel Utility Hooks: Kitchen Utensil Storage Organizer Hanger for counter. Kitchen tools sucker hooks can hang Spoon, beater, Spatula, scissors, towel and so on. Suction cup hooks for living room or bedroom to hanging bag, cloth, key, scarf and cap... Removable Shower Suction hooks: Bathroom Wall Hooks Hanger for Towel, Bath Robe, Coat, washcloth, shower cap, Loofah. Support for repeated use, simply wash the suction cup by water after removing, then the complete installation instructions to reuse it after drying. Innovative Suction Cup Holder Design: Strong Vacuum suction hooks holder allow you to install at any corner of the house. No tools, no drilling, no surface damage. Overload-maximum weight 5KG (11lbs). Ultra Strong Suction Ability: This suction cup base made of PVC (With a certain STICKY silicone material) which has good flexibility to release air. Suction cup work by the vacuum but the sticky PVC base which can help you place the suction cups easily. Optional installation wall surface: Only fix to clean, dry, flat, non-porous, shiny, smooth surfaces. Such as: glazed tiles, porcelain tiles, glass, mirror, stainless steel, plastic, acrylic, cultured marble. Surface has to be smooth for proper vacuum seal. It would not hold unless the surface is sealed to a point of stopping all air leakage. Please check again whether the wall is suitable for installation.